June 25, 2020 – I ran the plug wires on the engine.
I don’t have the plugs in yet, so I’ll probably have to adjust the wires a bit to clean this all up. For the lower wires I used clamps on the lower screws of the valve covers. I used a couple of automotive wire looms to keep wires straight behind the engine.
The upper wires need to be secured. On the right side the wires will run straight to the plugs from the baffle fairlead. On the left side I added clamps to the existing clamps for the fuel lines where they are secured to the pushrod tubes. I made spacers to separate the clamps.
Time: 2:00
