May 29, 2020 – I didn’t like how my starter cable was routed, so I made a new one.

Here’s how I originally had it. Kind of hard to see but you are looking for the thick white cable with the red heat-shrink end on it.

The cable ran under the starter, with a lot of potential for rubbing.

I ran the new cable straight back behind the starter, then across to the right side. The cable I made could have been maybe and inch or so shorter, but I can live with the gentle bend it has now.

The pictures show the routing from the starter back around to the start contactor. None of the clamps are tight. They will be tightened later on.

I made a stainless steel bracket for the clamp in the third picture. This is front and center on the sump.

Time: 3:20

Leave a Reply

Your email address will not be published. Required fields are marked *