April 27, 2021 – Now that the wings are on I can connect the wing wiring.

I safetied the tank attach bolts. Not sure why they need to be safetied, since they go into a nutplate that locks, but OK… I drilled the safety wire hole in the steel bracket.

I also installed the fuel lines.

I ran the pitot and AOA tubes into the fuselage and back to the ADAHRS, then connected the heat controller. Put power on the airplane and the heat works. I don’t have a message saying the heta is either on or off yet; I’ll set that up later in Dynon.

I ran and terminated the wires for the roll autopilot servo. The Skyview network portion is connected to the hub in the back.

I plan on connecting the wires for the lighting and the stick grips on a terminal bar under the left seat.

When I tried my lights, I had crossed the wires for the right landing light and the right nav lights. Got that figured out and now the lighting works correctly.

Time: 25:00

Leave a Reply

Your email address will not be published. Required fields are marked *