Panel Progress

January 24, 2021 – I’m getting dangerously close to having an airplane here…

I made a harness for the lights in my AML34 rocker switches. I decided to make one unified harness with one power and ground from the dimmer.

Here’s the bulbs in the switches:

Turned out that I needed to tweak the contacts in the switches a little bit to tighten the connections for the bulbs.

Here’s the harness I made with the dimmer.

…and the end result:

Here’s another photo of the mass of wires behind the panel, but I know that there is progress here.

I tried to run the ground wires for these front panel switches back to my firewall ground, but things are kind of tight and I really didn’t want to add to the spaghetti that was already there, so I made a local ground on the bulkhead forward of the panel. Not the most attractive, but it definitely works. These switches all provide grounds for the VPX, so there is no load on them.

After this I decided there was not much keeping me from getting ready to put everything in place and prepare to put power on, so I started installing panel items from the bottom up, keeping the big 10″ holes for access.

And here we are today… I have to tweak a few things and change a couple of connections for the Skyview network before I put power on. I also didn’t have the intestinal fortitude to even try putting power to it on that day. 🙂

Time: 22:00

Leave a Reply

Your email address will not be published. Required fields are marked *