Continued Work on Rudder Lower Fairing

March 6, 2020 – I continued the lower fairing on the rudder to prepare for the installation of the tail light.

I drilled the new screw holes to mount the fairing. The holes you see in this picture are the old ones, and they are filled with resin, so no worries about edge distance.

I installed the nutplates in the rudder.

I installed the chassis ground for the light. Not a lot of room in there. Hopefully this will be adequate. I removed one of the pop rivets and put a screw in its place, with a terminal on the inside.

Here’s a test fit of the light.

Time: 7:05

Leave a Reply

Your email address will not be published. Required fields are marked *