Assembled Left Inlet

September 13, 2019 – I assembled the left inlet including the air filter and snorkel.

I needed to know if the entire left forward baffles, ramp, and snorkel could be removed and installed as a unit, because of how I built it. Well, here it is:

While it was off, I needed to mod the snorkel down where the lower starter lug just touches it.

I just drilled a 1″ hole, and did a layup over that. Pushed the cloth down a little bit with my thumb to make a nice little divot.

I riveted the parts for this assembly.

Here’s the air filter installed with the retaining ring:

In the last post I mentioned how I bent the front side baffles to wrap under the ramps on both sides. I didn’t have good edge distance for the fasteners incorporating the air filter, so I cut that flange off of the left side baffle.

I temporarily installed this assembly back on the engine, and got ready to have everything in place to start trimming the tops of the baffles.

Here’s a couple of overview shots of the front baffles:

I wanted to protect the engine and accessories from the inevitable metal shavings from trimming the baffles to I did a little bit of FOD protection.

I put the top cowl in place. The baffles are tall and hold the top cowl off, so the tops of the baffles need to be trimmed, also allowing for about 3/8″ – 1/2″ for the baffle seal.

The front baffles appear to be the tallest, so I started with them. With the top cowl resting in place, I reached through and marked the baffles for cutting.

I cut this line and put the cowl back on. It’s getting there. I’ll work my way around the baffles so the cowl just drops into place evenly.

Time: 8:10

Leave a Reply

Your email address will not be published. Required fields are marked *