October 14, 2015 – I finished running the rudder cables through the bulkheads. As I stated in my last post, I had to figure out a way to get the cable ends through the snap bushings, since the bushings are smaller.
I just used two longer small screwdrivers, slid them into the bushing on each side of the cable end, and pried the snap bushings onto the cable.
I reinstalled the baggage compartment fixed side panels that I had to remove to get the cables through the bulkheads.
I also clamped the aft ends of the cables around the protective sleeves.
All that’s left on the rudder cables is to connect them to the pedals later on.
Time: 1:10
